Skip to content

Available 24/7 Emergency Gate Repair Service

Shield Gate Repair

Service

Automatic Gate Repair in Dallas–Fort Worth

Automatic gates fail in a small number of predictable ways, and most of them are cheaper to fix than people expect. We diagnose the actual fault instead of quoting a replacement because it is easier to sell.

What your gate is doing, and what it usually means

Most gate faults announce themselves in a fairly specific way. Find yours below — it will tell you roughly what you are dealing with before anyone arrives.

What you’re seeingUsually means
Gate will not openPower, board, capacitor, or a jammed track
Gate will not closeAlmost always a safety sensor seeing something that is not there
Gate opens and immediately reversesPhoto-eye misalignment or an obstruction in the beam path
Gate moves slowly or strainsBinding gate, worn rollers, or dropping hydraulic pressure
Gate is noisyChain, sprocket, roller or hinge wear — worth fixing before it takes the gearbox with it
Gate opens on its ownFaulty receiver, stuck remote button, or a loop detector fault

How we diagnose it

  1. Separate gate faults from operator faults by moving the gate by hand

  2. Check track, rollers, hinges and posts for alignment

  3. Electrical diagnostics on the operator

  4. Safety device test — photo-eyes, loops, edge sensors

  5. Full cycle test after repair

Watch the actual repair

Real automatic gate repair jobs

Photographs from our own job archive — real equipment, real repairs.

  • An automatic driveway gate part-way through its opening cycle
  • A gate operator and its control enclosure mounted beside a driveway gate
  • The inside of a gate operator with the control board exposed for testing
  • A safety sensor bracket knocked out of alignment on a gate post
  • A gate roller and track inspected for wear during a repair visit
  • A replacement capacitor fitted to a gate operator motor
  • An automatic gate closing fully against its stop after adjustment

Automatic Gate Repair questions

Why does my gate open but refuse to close?

Nine times out of ten it is a safety sensor. Photo-eyes are designed to stop a gate closing on a person or vehicle, so anything blocking or misaligning the beam — a spider web, a knocked bracket, sun glare at the wrong angle — will hold the gate open. It is one of the least expensive faults we fix.

The gate is fine but the remote is not. Is that expensive?

No — this is usually the cheapest call on our list. It is normally the remote itself or the receiver, not the operator.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives.

Call NowText UsEstimate